Our frame is round-tube DOM 1 1/2", 1/8" wall. The frame is jig assembled. The cockpit is stabilized with shear panels. The photo below does not have the outer panels installed nor the rear tunnel.
The frame is designed for any Chevrolet engine. The builder only needs to specify which engine/trans so that the mounts can be fabricated.
The foot boxes rest behind the headers so there is not a heat problem like the original.
The pedal assemblies are mounted into the top of the foot box.
Shown above is the mount location for the master cylinders. Pedal assembly is installed prior to shipping. Opening on the side is access to adjust balance.
Body in primer fastened to chassis. Firewall is welded to chassis and body mounts through to chassis.
Shown above is the bonnet hinged to the frame. Also shown is the mount for the Corvette rack and pinion.
|
